IT

Tracker / CVE-2025-39801

CVE-2025-39801

Medium 5.5

In the Linux kernel, the following vulnerability has been resolved: usb: dwc3: Remove WARN_ON for device endpoint command timeouts This commit addresses a rarely observed endpoint command timeout which causes kernel panic due to warn when 'panic_on_warn' is enabled and unnecessary call trace prints when 'panic_on_warn' is disabled. It is seen during fast software-controlled connect/disconnect testcases. The following is one such endpoint command timeout that we observed: 1. Connect ======= ->dwc3_thread_interrupt ->dwc3_ep0_interrupt ->configfs_composite_setup ->composite_setup ->usb_ep_queue ->dwc3_gadget_ep0_queue ->__dwc3_gadget_ep0_queue ->__dwc3_ep0_do_control_data ->dwc3_send_gadget_ep_cmd 2. Disconnect ========== ->dwc3_thread_interrupt ->dwc3_gadget_disconnect_interrupt ->dwc3_ep0_reset_state ->dwc3_ep0_end_control_data ->dwc3_send_gadget_ep_cmd In the issue scenario, in Exynos platforms, we observed that control transfers for the previous connect have not yet been completed and end transfer command sent as a part of the disconnect sequence and processing of USB_ENDPOINT_HALT feature request from the host timeout. This maybe an expected scenario since the controller is processing EP commands sent as a part of the previous connect. It maybe better to remove WARN_ON in all places where device endpoint commands are sent to avoid unnecessary kernel panic due to warn.

Affected products and versions

debian debian_linux
linux linux_kernel
linux linux_kernel · 3.2 → 5.15.190
linux linux_kernel · 5.16 → 6.1.149
linux linux_kernel · 6.13 → 6.16.4
linux linux_kernel · 6.2 → 6.6.103
linux linux_kernel · 6.7 → 6.12.44

Analysis

This page is not indexable yet.Until it carries original analysis — what it actually exposes, how to check in two minutes whether a system was touched, what to do if it was — the page stays noindex. The database decides that, not the template.

References